System Overview - Velleman SPBS8 Notice D'emploi

Box includes
•
1 LCD display with mounting stand and cable
•
1 front controller unit
•
1 rear controller unit
•
8 sensors
•
4 front sensor cables of 4,5m each, numbered 5~8
•
4 rear sensor cables of 2,5m each, numbered 1~4
•
1 on/off switch with cabling (2,4m)
•
1 power cable for rear ECU
•
1 cable to connect front and rear ECU
•
1 drill Ø18,5mm for sensor mounting
•
1 user manual
•
Cable clips
•
Double sided adhesive tape

5. System overview

6. Installation
DO NOT apply power to the system before all connections are made.
Sensors
•
Choose the location of the sensors on the bumper carefully, as the proper functioning of the
system depends on it.
Note: beware that detection results might be affected when sensors are installed in steel bumpers.
•
Refer to the picture below for the best horizontal and vertical position. L=width of the vehicle.
01 (09/10/2008)
SPBS8
A. Rear Electronic Control Unit
A1. DC +12V (from reverse light)
A2. GND
B. Front Electronic Control Unit
B1. ACC +12V
B2. GND
B3. DC +12V (from brake light)
C. Display unit
D1~D8. Sensor
E. Reverse light
F. On/Off switch
3
®
Velleman