Specialist Installer Qualification; Safety Instructions - Maico MVE 10 Notice De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

UK │ 6. Safety instructions
2. Scope of delivery
MVE 10 motor protection switch, 2 cable
grommets and these mounting instructions.

3. Specialist installer qualification

The MVE 10 may only be installed by a
trained electrician, in line with these
instructions. You are deemed competent if
you can competently and safely connect units
to an electrical power supply in line with the
wiring diagram, on the basis of your technical
training and experience and are able to
recognise and avoid risks and dangers
associated with electricity.
4. Intended use
MVE 10 motor protection switch for single-
phase
AC fans with fitted thermal contacts. MVE 10
with main contactor and control fuse. The
MVE 10 is only intended for domestic use
and similar purposes.
5. Non-intended use
DANGER
Explosion hazard if operated in an
explosive atmosphere in the case of
ignition, e.g. from sparks.
The MVE 10 should never be deployed in
potentially explosive atmospheres.
NOTICE
Unit damage through modifications and
alterations. Modifications and alterations to
the unit are not permitted and release the
manufacturer from any guarantee and
liability.
NOTICE
Damage to the unit when used
outdoors. The MVE 10 should only be
deployed indoors.
6

6. Safety instructions

WARNING
Risks for people (including
children) with reduced
physical, sensory or mental
capabilities or a lack of
knowledge.
The MVE 10 may only be
installed, commissioned,
cleaned and maintained by
people who can safely
recognise and avoid the risks
associated with this work.
DANGER
Danger from electric shock.
Before accessing the
connection terminals:
Switch off all supply circuits.
Cover or block off neigh-
bouring live components.
Protect against being acci-
dentally switched back on.
Check that there is in fact no
voltage present.

Publicité

Table des Matières
loading

Table des Matières