(Uk) Product Package; (Uk) Introduction - TIPTEL 4S0 Instructions D'installation

(UK) Product package

Please check that you have received everything before starting installation. The de-
livery package consists of:
•
1 module (without casing)
•
1 connector strip (20-pole)
•
2 hexagon bolts (for plastic threads, not for tiptel.com 822 XT Rack)
•
2 screws (not for tiptel.com 822 XT Rack)
•
1 set of installation instructions (this manual)

(UK) Introduction

The module for the tiptel.com 822 XT rack contains a double socket board so that (as
for the basic device) you can have a separate connection socket per subscriber for
each terminal. This maintains the familiar adaptation to structure cabling via patch
fields.
The additional connections are available as usual in the programming interface
menus in all systems. Please note that you require a firmware version stated below or
higher, so please do an update if necessary.
This expansion component is only to be used within tiptel .com 822 XT tele-
phone systems. Use with other systems can lead to the destruction of the com-
ponent and the system.
Only terminals that meet the European requirements on electrical safety may be
connected to this extension component. Devices with the CE symbol must meet
these requirements.
4S0
8ab
2FXO/4FXS
4S0/UP0
tiptel.com 822 XT / Rack
---
√ Firmware > 5.6.18
√ Firmware > 6.3.5
√ Firmware > 6.3.5
Notes
√ Firmware > 3.1.36
7
tiptel 30xx / Rack
---
---
---