Repairs - Veromatic MBI01 Installation, Utilisation Et Entretien

Repairs

7.2
!
WARNING
Repairs are understood to be anything for which tools are needed to work on the machine.
Those repairs may only be done by authorized technicians (see also paragraph 3.1). For any
repairs only original parts may be used.
The demands made from a technician are:
1 The technician has to be informed of all laws and regulations regarding electrical connections,
electrical symbols, etc.
2 The technician is very familiar with the machine, by training with Veromatic International B.V.
or similar training obtained elsewhere.
3 The technician uses the instructions, diagrams etc., applicable for this type and model.
4 The technician takes all security precautions for himself and others so as not to be exposed to
any danger, electrical as well as mechanical.
5 The technician is well aware of the applicable guidelines regarding hygiene.
The technician must take the following precautions while working on this machine:
1 Unplug the plug from the wall outlet.
2 Check to see if possible ground connections that have been loosened are functioning again.
3 Observe all general safety directions (see chapter 1)
In case some parts have to be replaced, contact your dealer.
To replace parts, use only original (spare) parts, issued by Veromatic International B.V. These satisfy
strict quality demands which assure that the machine continues to function optimally. If original parts
are not used, the warranty is null and void and Veromatic International B.V. is not responsible for
possible damages resulting thereof.
52
EN