How To Use Your Steam Generator Iron - Dupray STEAMIRON Manuel D'utilisation

HOW TO USE YOUR STEAM GENERATOR IRON

FILLING WITH WATER
Remove the boiler cap (2) and fill the boiler with 1L (34 oz) of water. Securely replace the boiler cap.
IMPORTANT:
Never put anything else than clean water inside the boiler.
IMPORTANT:
Do not overfill with water. Leave space for steam!
PLUGGING IN THE MACHINE
Unravel completely the electrical cord and connect it to a 13 A 230 V outlet
(make sure the circuit is not already used by another high wattage appliance).
TURNING THE MACHINE ON
STEAM IRONING: Turn the main dial (1) to the position and wait about 10 minutes
for the SteamReady™ indicator (3) to light up. Set the thermostatic control (C) to the
position that corresponds to the fabric you wish to iron. When the thermostat light (D)
goes off, the steam iron has reached proper temperature and is ready to use.
NOTE:
The thermostat light (D) will come on and off during use to maintain the iron plate at the optimal temperature.
IMPORTANT:
Always follow the manufacturer's ironing recommendations for the fabric.
DRY IRONING: Turn the main dial to the position and set the thermostatic
control (C) to the position that corresponds to the fabric you wish to iron. When
the thermostat light (D) goes out, the iron has reached the proper temperature
and is ready to use.
NOTE:
In this position the unit will not produce steam.
NOTE:
Do not press the steam release button (A) to iron without steam.
RELEASING STEAM
Press the steam release button (A) on the iron's handle to release steam
or press the locking button (B) for a continuous steam flow.
NOTE:
The first time you use your steam generator iron, release steam for
1 minute to make sure there are no production deposit left in the iron.
NOTE:
The soleplate must be hot to prevent the steam from condensing
on the soleplate and dripping onto the garment.
REFILLING WITH WATER
When the low water indicator (5) comes on during usage and you would like to continue ironing, you will need to follow these steps:
Before refilling with water, turn the main When all steam has been exhausted from
dial to the position and hold the the boiler, turn the main dial to the OFF
steam release (A) button to release all position and wait 10 minutes for the
pressure inside the boiler. boiler to cool down.
IMPORTANT:
Do not overfill with water. Leave space for steam!
WARNING:
If all steam pressure has not been released, steam may escape from the boiler cap when opening, use caution.
Open the boiler cap (2). Using the Turn the main dial to the position
funnel, pour 1L (34 oz) of water (for dry ironing) or to the position
inside the boiler. Refasten the (for steam ironing). Wait 10 minutes for
boiler cap. the SteamReady™ indicator (3) to light up
and the thermostat light to go off.
Continue ironing.
en
8