Information Codes - Samsung WA48H7400A Manuel D'utilisation

troubleshooting

informAtion codes

The Washer may display information codes to help you understand what is occurring with your Washer better.
code symbol meaning
1e
4e
5e
le
ue
de
de1
de1
be2
3e
ae
WA7000HA WASH_WA48H_USER MANUAL_DC68-03133P-13_EN.indd 32
The Water Level sensor is not
working properly.
When washer displays "1E",
washer will drain for 3 minutes.
At this time, the Power button is
invalid
Your Washer has tried to fill but
was unsuccessful.
Check if the hot water supply
hose is connected.
When washer displays "4E",
washer will drain for 3 minutes.
At this time, the Power button is
invalid.
Your washer is not draining. It can
also mean that the unit senses a
small clog while draining.
Your Washer has tried to fill but
has not reached the proper water
level.
When washer displays "LE",
washer will drain for 3 minutes.
At this time, the Power button is
invalid.
Unbalanced load prevented your
Washer from spinning.
Lid is open when washer is
running.
Your washer failed to lock or
unlock the lid.
The door will not unlock.
A jammed Key.
Motor not running properly.
Communication error between
SUB PBA and MAIN PBA.
English - 32
solution
Call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, then please
remove the device and connect the water hoses
directly to the unit.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function.
Do the following:
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
If it still does not drain, call for service.
Call for service.
Redistribute the load, press the Start/Pause
button.
Close the lid tightly and restart the cycle. If the
code reappears, call for service.
Close the lid tightly and restart the cycle. If the
code reappears, call for service.
Make sure the lid is firmly closed.
Push the Power button to turn off your washer,
then turn it on again. If the code reappears, call
for service.
Call for service.
Restart the cycle pressing the Start/Pause
button. If the code reappears, call for service.
Call for service.
2016/6/22 10:33:27