Dutchblue 5026-B Mode D'emploi page 41

BATTERY BACKUP
• During a power failure, the lift chair's battery backup system will automatically switch on. This
system is designed to take you from reclined to sitting position only. The battery backup system
is powered by two 9V alkaline batteries (not included).
• Always make sure the lift chair's battery backup system is equipped with two charged 9V
alkaline batteries, since the system does not recharge itself. Batteries are assumed charged
when 9V alkaline batteries are replaced every time the battery backup system is activated
during a power failure, or once a year if the battery backup system has not been activated.
• If you unplug the lift chair for an extended period of time (more than one hour), remove the
batteries. The lift chair will draw power from the batteries even when it is not in use.
Caution:
• When sitting down in the chair, never "drop" into it if it is partially raised.
• The external transformer is packaged independently from the lift chair. Please DON'T
discard any packaging before locating the external transformer.
• Make sure the external transformer is plugged into a properly wired outlet and check the
circuit breaker box.
• Make sure the connection cable from the chair is properly plugged into the external
transformer.
• Make sure the hand control and motor are plugged in properly.
• Check if the motor is plugged into the low voltage connection cable that goes into the
external transformer.
• Check the up/down switch of the hand control to make sure there is a smooth movement
from the "↓" and "↑" position. If the switch sticks in either position, the hand control may
need to be replaced.
• If the lift chair rocks from corner to corner after you position it, the floor may be uneven or
the carpet may be affecting the chair position. Adjust the leg levelers at the area where the
chair is rocking.
NL
dutchblue.com
41