Dutchblue 5026-B Mode D'emploi page 39

55 cm
• Allow sufficient space in front and behind the chair for the reclining movement.
• Make sure there is an allowance of more than 55 cm behind the chair and more than 31 cm in
front of the chair.
• Place the chair near a properly wired standard wall outlet.
• Place the chair on a flat surface/floor in a dry room.
• Adjust the leg levelers to keep the chair stable.
• Turn the leg levelers clockwise to raise the chair and counter-clockwise to lower the chair.
• Lay the low voltage connection cable, located at the back of the chair, where it will not be
pinched between the wooden frame and the lifting mechanism. If the low voltage connection
cable is not already connected to the external transformer, connect it.
• Ensure the external transformer, power cord, and the low voltage connection cable are not
damaged or wet.
Caution:
• Make sure there is no obstruction behind or in front of the chair for a safe recline and lift
during operation.
• Plug the electrical chord directly into the outlet. DON'T use an extension cord!
• No body parts or objects should be placed between the chair and the footrest.
Warning!
Before attaching the back of the lift chair, place the hand control in center of the cushion.
Improper hand control cable routing can lead to equipment damage & malfunction.
NL
PLACING OF THE CHAIR
dutchblue.com
31 cm
39