Installation And Assembly Instructions - Pioneer PDK-FS06 Mode D'emploi

Installation and assembly instructions

1
Attaching the support columns to the stand.
Table of support column position and parts
for each plasma display
Plasma display
Location of speakers
Support column position
Attachment method
Support column
stopper
Screw (M5 x 10mm)
Plasma display
attachment use
Used
top hexagonal
parts
bolts
Plasma display
attachment use
bottom hexagonal
bolts
Support column
stopper
Unused
Screw (M5 x 10mm)
parts
Hexagonal bolts
The attachment procedure varies according to the type
and form of the plasma display to be attached. Perform
this attachment using either procedure A, B or C.
Note
Be sure to carefully store the unused support column stopper,
the screws, the bolts, the hexagonal wrench, and the Operating
Instructions together.
A
When installing PDP-506XDE, PDP-506FDE,
PDP-506HDG, PRO-1130HD, PRO-930HD,
PDP-5060HD or when installing speakers at the
sides of PDP-436XDE, PDP-436FDE, PDP-436HDG
Insert the support columns into the stand and fix them in
place with screws (M5 x 10mm [13/32 inch]). (8 locations)
Install each support column so that the side with the symbol
' is forward and the end with the plastic end cap (pointed) is
upwards.
End with end cap
points upwards.
Side with the
symbol ' is
forward.
Screw
(M5 x 10 mm
[13/32 inch])
4
En
PDP-436XDE
PDP-506XDE
PDP-436FDE
PDP-506FDE
PDP-436HDG
PDP-506HDG
PDP-5060HD
PDP-4360HD
—
PRO-1130HD
PRO-930HD
Side Side Under
LOW LOW HIGH
A A B
Unnecessary Unnecessary High position Low position
– – 2
Short ×2 Short ×2 Short ×2
Short ×2 Short ×2 Short ×2
2 2 –
2 2 –
Long ×2 Long ×2 Long ×2
Support column
(43-inch display model in the figure)
B
When installing speakers at the bottom of the
plasma display
Attach the support column stoppers to the high position notches
on the back of the stand and fix them in place with screws (M5
x 10mm [13/32 inch]). (2 locations on the right and left)
One body type
The same applies to support column attachment method A.
plasma display
–
MIDDLE
C
2
Long ×2
Short ×2
–
–
Short ×2
C
When installing one body type plasma display
Attach the support column stoppers to the low position notches
on the back of the stand and fix them in place with screws (M5
x 10mm [13/32 inch]). (2 locations on the right and left)
The same applies to support column attachment method A.
Support column
stopper
Screw
(M5 x 10 mm [13/32 inch])
Support column
stopper
Screw
(M5 x 10 mm [13/32 inch])