Pioneer PDK-FS06 Mode D'emploi page 6

Installation and assembly instructions
4
When using a shelf.
A shelf can be attached to the stand.
1 Remove the shelf cover and then attach the shelf supports
L and R to the stand.
Push rivet
Shelf support R
2 Push the shelf panel in from behind and fix it in place with
the push rivet.
The shelf panel installation position be selected from
two levels: either the front or the back.
Set it accorrding to the device you have.
When changing its position, you can easily remove it
by pulling up the knob on the top of the push rivet.
nterior dimensions of the shelf opening: 420 mm [16-
I
17/32 inch] (effective width) <opening 436 [17-5/32] >
x 102 mm [4-1/32 inch] (height)
Depth of the shelf: 349 mm [13-3/4 inch]
Bearing capacity: up to 10 kg [20.1 lbs]
Note
Be careful when installing anything other than a media
receiver (particularly an AV amplifier etc.) on this shelf,
because it may block heat discharge etc. For details, see
the instruction manual for each device.
Unlocked
position
Locked
position
6
En
Shelf cover
Shelf support L
Push rivet
Push in
Hole for front
position use
Hole for back
position use
Shelf panel
Push rivet
c k
B a
o n
s i t i
p o
n t
F r o
o n
s i t i
p o
Front side
5
When attaching a media receiver upright.
1 Fit the MR holder over the sides of the media receiver and
fix into place using the four screws (M4 x 6 mm [1/4 inch]).
Note
The legs of the MR holder are on the side of the holder
with the indentations. Be sure to attach the holder in
the correct direction.
Do not attach the MR holder to anything other than a
media receiver.
Rounded edges
MR holder
Indenations
Media
receiver
2 Put the media receiver installed on the MR holder on the
shelf at the rear and fix the MR holder in place.
Note
Please make sure the media receiver is facing the proper
direction.
Do not install any device other than a media receiver in
this position.
Rounded
edges
Screws (M4 x 6 mm
[1/4 inch])
Screws
(M4 x 6 mm
[1/4 inch])