EHEIM CLEAR UVC-24 Mode D'emploi page 18

English
5. Operation
Switch on the UVC clarifier
ATTENTION! Electrocution!
▶ Place the UVC clarifier at a minimum of 2 m from the pond bank.
CAUTION! Material damage.
▶ Never operate the UVC clarifier without a water flow. The water serves to cool the UVC lamp.
1. Place the UVC clarifier on a stable surface, attach the UVC clarifier to a solid base.
2. Install the corresponding hose connections.
3. Insert the mains plug in the mains socket. Attention: The UVC clarifier is immediately ready for
operation!
The transparent screw connections illuminate when the UVC lamp is working properly.
Switch off the UVC clarifier
1. Remove the mains plug from the mains socket.
6. Maintenance
ATTENTION! Electrocution!
▶ Before all maintenance work, remove the mains plug.
WARNING! Danger of injury.
The glass bulb and UVC lamp are fragile and breaking the glass can lead to cuts.
▶ Handle the glass bulb and UVC lamp carefully.
CAUTION! Material damage.
▶ Do not use hard objects or aggressive cleaning agents for cleaning.
The following sections describe maintenance work necessary for optimum and fault-free operation.
Regular maintenance prolongs the service life and assures functionality of the UVC clarifier over a long
period.
Cleaning the glass bulb
1. Remove the mains plug.
2. Unscrew the lamp holder. Press the unlocking button, rotate the lamp holder in an anti-clockwise
direction and remove the lamp holder from the housing (⌦G).
3. Clean the glass bulb with a standard glass cleaner.
4. Install the lamp holder again in reverse order. Also push the lamp holder's locking lugs through the
corresponding openings in the housing (⌦L).
5. Rotate the lamp holder in a clockwise direction until it locks into place.
18