TFA easy meteo Manuel D'utilisation page 44

TFA_ANGLAIS 21/04/05 14:44 Page 44
If you live in an area of electromagnetic disturbances (as this is very
frequently the case due to numerous domestic appliances in use) and if
the main unit would "lose" one of its sensors as a result at one time, an
automatic search would be launched for 2 min and 10s. If the sensor(s)
was(were) not found at the end of this procedure, an automatic search
would then be started every hour for a 24h period. During these
automatic search operations, the word Synchro is displayed. This
automatic search procedure is a world exclusive feature of your EASY
METEO.
To display the temperature and humidity of the selected sensor (in for
main unit, 1, 2 or 3 or alternately, refer to page 40 - Sensor menu key.
STEP 3 - MAIN UNIT SETUP
If all the following settings are not carried out, your device
will not operate under normal conditions and might not provide
full satisfaction. Since the device is calculating a moving average,
it is advisable to carry out the setting after a few minutes of
operation.
AUTOMATIC CALENDAR SETUP
This device was designed with time set automatically to DCF 77
(Frankfurt) with a high level of sensitivity.
15 seconds after LCD display switched on (See page 42), DCF 77 icon
starts flickering slowly indicating that automatic search of time by your
EASY METEO has started and will last for 4 min and 16s. The full and
correct reception of time results in automatic time reset of main unit: the
new time and date are then displayed and icon DCF 77 starts flashing.
Putting time forward or back
It is possible to put time forward/back by one hour compared to the time
given by the automatic reception (for example, United Kingdom or
Poland).
To put time forward by one hour, press the key for 5 seconds. The
time displayed will be + one hour earlier than the time received by the DCF,
and the precision given by the signal DCF 77 will thus be maintained.
Operate in the same way to put time back by one hour
Activating/Deactivating the automatic time search
To activate or deactivate the automatic time, press
To activate it, hold key pressed down until the DCF symbol is
displayed; to deactivate it, hold key pressed down until the three full
lines are displayed.
44