Product Overview; Xac1200; Top View; Back View - Linksys XAC1200 Guide De L'utilisateur

Linksys XAC-Series Linksys XAC-Series Linksys XAC-Series

Product Overview

XAC1200

Top view
•
Indicator light—Solid green when on, and after a successful Wi-Fi
Protected Setup connection. Blinks slowly while booting up during
firmware upgrades, and during a Wi-Fi Protected Setup connection
Blinks quickly when there is a Wi-Fi Protected Setup error.

Back view

Ethernet ports
•
Wi-Fi Protected Setup™ button—Press to configure wireless security
on Wi-Fi Protected Setup-enabled network devices.
•
USB port—Share disk storage with other users on your network or on
the Internet. Connect a USB drive to this port. You can also connect a USB
Indicator light
printer and share it across your network.
•
Ethernet ports—Connect Ethernet cables (also called network cables)
to these blue Gigabit (10/100/1000) ports, and to connect wired Ethernet
network devices to your network.
NOTE
For best performance, use CAT5E or higher rated cables.
•
Internet port—Connect an Ethernet cable (also called a network or
Internet cable) to this yellow port and to your modem.
•
Reset button—Press and hold for 10 seconds (until the port lights blink
at the same time) to reset the router to factory default settings. You can
also restore default settings using Linksys Smart Wi-Fi.
•
Power port—Connect the included AC power.
•
Power button—Press | (on) to turn on the router. (EU models only.)
Internet port
USB port
Wi-Fi Protected Setup™ button
Product Overview Product Overview
Reset button
Power port
1 1 1