Product Overview; Ea9200; Front View; Back View - Linksys EA9200 Mode D'emploi

Linksys EA9200

Product overview

EA9200

Front view

• Indicator light — The Linksys logo stays on steadily while power is
connected and following a successful Wi-Fi Protected Setup connection.
Flashes or pulses slowly during bootup, during firmware upgrades, and
during a Wi-Fi Protected Setup connection. Flashes quickly when there
is a Wi-Fi Protected Setup error.

Back view

The ports/buttons from left to right: USB 3.0, USB LED, USB 2.0, USB LED,
Ethernet ports (1-4), Internet port, Power port, Power switch, Reset button
• USB ports — Connect and share a USB drive or a USB printer.
• USB LEDs — Illuminate when a USB drive is connected. Flash when
data is being transferred.
• Ethernet ports — Connect Ethernet cables to wired Ethernet network
devices.
NOTE
For best performance, use CAT5E or higher rated cables on the
Ethernet ports.
•
Internet port — Connect an Ethernet cable to your modem.
• Power port — Connect the included AC power adapter.
•
Power switch — Press | (on) to turn on the router.
• Reset button — Press and hold for 10 seconds (until the port lights
flash at the same time) to reset the router to factory defaults. You can
also do this using Linksys Smart Wi-Fi.
Product overview
1 1