Machine Elements; For Your Safety - Bosch GWS 21-180 H Professional Instructions D'emploi

Machine Elements

The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Thread for auxiliary handle (3x)
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protection guard
7 Adjustment screw
8 Clamping lever
9 Mounting flange with O-ring
10 Grinding/cutting disc*
11 Clamping nut
12 quick-clamping nut*
13 Clamping screw
14 Coded projection
15 Guard, grinding cup*
16 Grinding cup*
17 Two-pin spanner for clamping nut*
18 Hand guard*
19 Spacer discs*
20 Rubber sanding plate*
21 Sanding sheet*
22 Round nut*
23 Cup brush*
24 Diamond cutting disc*
25 Cutting guide with dust extraction
protection guard*
26 Handle unlocking button
27 Handle
28 Cutting grinder stand*
* Not all of the accessories illustrated or described are
included as standard delivery.
16 • 1 609 929 R35 • 03.11
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
Wear protective glasses and hearing protec-
tion.
Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always direct the cable to the rear away from
the machine.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
For power outage or when the mains plug is
pulled, unlock the On/Off switch immediately
and turn it to the off position. This prevents un-
controlled restarting.
The machine must be used only for dry
cutting/grinding.
For all work with the machine, the auxiliary
handle must be mounted.
English - 2

For Your Safety

Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained
strictly followed. In addition, the
therein are