Santoemma Charis Manuel D'utilisation Et De Maintenance page 15

 The brush motor is protected from overload, by a protection located on the control panel. If this
protection intervenes, it is necessary to reduce the pressure of the brush, to avoid the overload of the
motor. If this is not enough to avoid that the protection repeatedly intervenes, you should contact the
technical assistance. The repeated intervening of the protection might result in faults which cannot be
covered by warranty.
Keep an adequate safety distance from other people, who could be run over by the machine. Pay

attention to any object that could be hit by the machine. Never leave the machine unguarded.
 Do not let the pump function without water! This could cause a damage of the pump.
 The machine should not be used to vacuum dust, which would be sucked by the vacuum motor,
damaging it.
 Verify that the brush inserted in the machine is the appropriate type for the surface to be cleaned. In
particular, the optional specific brush for hard floor should not be used on carpet, since it might be too
aggressive for carpet and damage it, or it could cause an overload of the brush motor.
In this modality the machine works as a box extractor. After filling the tanks with solution and inserting
the plug in the wall outlet (see steps 1 and 2 of the paragraph Preparation for Work as a self contained
machine for carpet), you need to do the following:
1. Connect the machine to the wand or to the hand-tool using the dedicated vacuum hose and solution
hose. To connect the hoses to the machine, remove the hose connecting the upper tank to the
vacuum head and the solution hose, which connects the pump to the spraying nozzles, situated under
the machine.
2. Switch on the vacuum motor by setting their switch to position "I", and the pump by setting the
switches to position "II". In this way the solution pump always works and it is not necessary to keep
pressed the control lever situated on the control panel.
3.
To spray water you need to press the lever situated on the handle of the accessory.
To clean hard floor, it is enough to connect the optional squeegee to the machine. Raise the vacuum
head pressing the handle down and put the brushes in the "Pre-Brushing position". In this way, Charis is
ready to clean small hard floor areas.
ATTENTION:
Use with Accessories
Cleaning hard floor
15