Troubleshooting Guide - Tokai M038 Manuel D'utilisation

If a fault occurs, first check the points listed below before taking the set to repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
PROBLEM
NO SOUND
NO POWER
No DISC indication
The CD playback does not
start
CD/MP3/USB playback does
not work
The CD/MP3 skips tracks
Radio stations
tuned in
The remote control does not
work properly
TROUBLE SHOOTING GUIDE
Volume not adjusted
Check whether you selected right
function.
Power
connected
No CD/Mp3 inserted
CD badly scratched or dirty
CD-R is blank or the disc is not
finalized.
An unplayable disc is inserted
CD/MP3/USB is badly scratched /
dirty.
Laser lens steamed up
CD/MP3 damaged or dirty
Program is active
cannot be The antenna is badly positioned or
connected poorly
The remote control is too far from
the unit
There is an obstacle between the
remote
remote sensor
The battery in the remote control
is exhausted
CAUSE
GENERAL
cord not securely
CD PORTION
RADIO
REMOTE CONTROL
control and the
33
SOLUTION
Adjust the Volume
Press SOURCE button and select
the correct source.
Connect the
properly
Insert a CD, Mp3 or CD-R.
Replace / Clean the CD, see
Maintenance.
Use a finalized CD-R
Insert a playable disc
Replace/Clean CD/MP3/USB (see
maintenance)
Wait until lens has adjusted to
room temperature
Replace or clean the CD/MP3.
Quit the Program mode
Connect the antenna securely and
fully extend the Antenna for best
reception
Operate the remote control within
about 7 m (23ft).
Remove the obstacle.
unit
Replace the battery with a new
one.
AC power cord