Radio Operation - Tokai M038 Manuel D'utilisation

Compatible USB Device:
- Mp3 player: Flash type Mp3 player.
- USB Flash Drive: Devices that support USB2.0 or USB 1.1.
- The USB function may not be available depending on device.
- Device which require additional program installation when you have
- connected it to a computer, are not supported.
Do not extract the USB device while in operation.
Tips for Better RADIO Reception:
1. To insure maximum FM tuner reception, the telescopic Antenna should be fully extended and rotated
to obtain the best possible radio reception.
2. The AM antenna is built into the unit. When tuning in AM reception, be sure to place the unit in a
vertical position. To insure best AM reception, try repositioning the unit until the best station reception
is obtained.
1. Press POWER button to turn the player on.
2. Press the SOURCE button repeatedly to select AM or FM mode.
The radio frequency will show on LCD display.
3. Press and hold the SKIP + / TUN + button or SKIP - / TUN– button to search for the next /
previous available station. If the reception is poor, try manual tuning to fine tune the station.
4. Press the SKIP + /TUN + button or SKIP - / TUN- button briefly to manually tune through the
frequency band.
5. Adjust the volume control to the desired volume level.
6. Press the SCAN button. A bar graph indicating the progress of the RADIO station search will be
displayed. The number of stations found increases as the scan progresses.
Setting the Radio Station Presents
The unit allows you to store up to FM 20 stations and AM 10 stations for easy recall at any time.
1. Tune to the radio station you want to store in memory.
2. Press Prog/Mem button. The preset program number "P01" will be flashing on
3. To change the program number location,
numbers ( P01-20 in FM mode or P01-10 in AM mode ).
4. To confirm the preset location, press the
5. To store up to 20 station presets in FM mode or 10 stations presets in AM mode, repeat steps 1-4
above.
Recall preset station
In AM or FM mode, press MEM+/- buttons repeatedly to cycle through your memory presets and select the
preset channel.

RADIO OPERATION

press the MEM+/- buttons to step through the program
Prog/Mem button.
30
display.