Usb Operation - Tokai M038 Manuel D'utilisation

Loading and Playing a CD/MP3
CD/MP3 OPERATION
Up to 20 tracks for CD disc, 99 tracks of mp3 disc can be programmed for disc play in any order. Be sure to press the
"Stop" button before use.
1. Press the SOURCE button to switch to CD mode.
2. Open the disc door.
3. Load a CD or CD-R/RW disc into the unit label side facing up.
4. Close the disc door.
5. Press the Play/Pause button to begin playing the loaded CD. Press the Skip/Search buttons to
cycle through different tracks.
Programming a CD
1. Press the STOP button to stop the CD.
2. Press the Prog/Mem button on the remote.
3. Press the Skip/Search buttons to select a track from the loaded CD to play irst.
4. Press the Prog/Mem button again.
5. Repeat steps 3 and 4 to program tracks from the loaded CD to play in the order they are selected.
6. Press the Play/Pause button to begin playing the programmed CD.
7. Press the Stop button twice to cancel the program.
8. Press and Alarm/+10 button 2 second then playback go up 10 tracks (for example : 01
ERASING A PROGRAM
You can erase the content of the program by :
-While playing, press STOP button twice,
-Opening the CD door,
-Select other source mode.
You can enjoy media files saved on an USB device by connecting the USB device to the USB port of the unit.
1. Connect the USB device to the USB port compatible of the unit.
2. Press the SOURCE button on the remote control or SOURCE button repeatedly on the main unit front
panel to select the USB function.
3. Select desired file to be played back by pressing the  or  buttons.
4. Press PLAY/PAUSE button, the playback will start. Press again to pause playback, press again to resume
playback.
5. Press the  or  buttons to go to the next track or back to the previous track.
6. Press STOP  button to stop all USB operation.
7. Press and Alarm/+10 button 2 seconds then playback go up 10 tracks (for example : 01
CD / MP3 OPERATION

USB OPERATION

29
>11>21...).
>11>21...).