Commissioning The Device; Risk Of Burns; Changing Wxmp Soldering Tips - Weller WXMT Mode D'emploi

WXMP/WXMT
WARNING!
WARNING!
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
WXMT
Heating output
Voltage (heater)
Heat-up time
Connection
Weight
Tip type
Supply unit

5 Commissioning the device

Risk of burns

The soldering tips of the soldering iron and desoldering tweezers
become very hot during soldering and desoldering.
There is a risk of burns from touching the tips.
Do not touch the hot soldering tips and keep them away from
inflammable objects.
1. Carefully unpack the WXMP soldering iron or WXMT desoldering
tweezers.
2. WXMP:
Place the soldering iron into the safety rest (WDH 50).
WXMT:
Place the tweezers into the safety rest (WDH 60).
3. Insert the connecting plug (5) into the socket on the power supply
unit and lock the plug into the socket by turning it clockwise.
4. Check to make sure that the mains voltage matches the voltage
specified on the rating plate of the WX supply unit.
5. Switch on the supply unit and set the desired temperature.
6. Once the tool has reached the desired temperature, coat the
soldering tip in solder.

6 Changing WXMP soldering tips

Risk of burns
The soldering tip becomes hot during soldering and desoldering
processes.
There is a risk of burns from touching the soldering tip.
The soldering tool must be switched off and stand at least 3
min. in the safety rest (WDH 50) until the soldering tip has
cooled off. Only replace the soldering tips when they are cold.
80 W (2 x 40 W)
12 V
(approx.) 3s (50°C to 380°C) (120°F to
660°F)
7 pin connector, polarity protected with
lock
42 g incl. tip cartridge without cord
RTW series
Weller WX stations
7-10