Device Description; Technical Data - Weller WXMT Mode D'emploi

6-10
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com

4 Device description

4.1 Soldering iron WXMP
The WXMP is a powerful 40 W (55 W with RT 11) fine soldering iron
with integrated heating system in the soldering tip. Thanks to a plug-
in system, the soldering tip can be changed without tools.
The WXMP is equipped with a usage detector and can be
automatically switched to standby mode or switched off when not in
use. For details of setting the standby temperature and the switching
times, please refer to the operating instructions of the WX supply
unit in use.
Note The WXMP soldering iron by Weller may only be used with Weller
WX supply units.
4.2 Desoldering tweezers WXMT
The WXMT desoldering tweezers by Weller have been developed
for the re-working and repair of electronic SMD precision tools. The
soldering/desoldering tip set can be replaced easily and quickly
without tools. The tips are pre-calibrated and require no further
alignment. The built-in heating elements (2 x 40 W) ensure that the
desired soldering tip temperature is reached very quickly and
precisely. The WXMT desoldering tip comes equipped with a usage
detector and can be automatically switched to standby mode or Off
when not in use. For details of setting the standby temperature and
switching times, please refer to the operating instructions of the WX
supply unit in use.
Note The WXMT desoldering tweezers may only be operated with WX
supply units

Technical data

4.3
Temperature range
Tool cable
Heating element
Sensor
WXMP
Heating output
Voltage (heater)
Heat-up time
Connection
Weight
Tip type
Supply unit
100°C - 450°C (212°F - 850°F)
Silicone rubber, heat resistant
Heating wire integrated in tip cartridge
Thermocouple integrated in tip cartridge
40 W (55 W with RT 11)
12 V
(approx.) 3s (50°C to 380°C) (120°F to
660°F)
6 pin connector, polarity protected with
lock
26 g incl. tip cartridge without cord
RT series
Weller WX stations
WXMP/WXMT