Makita HW1200 Manuel D'instruction page 6

To introduce water into the hose, remove the nozzle
from the trigger gun and switch on the high pressure
washer while the trigger is squeezed. Once water is
ejected stably from the trigger gun, release the trigger
and attach the nozzle for your purpose.
1
► 1. Trigger gun
NOTE: When water is not ejected, detach the suction
hose set and soak it in water. Then reconnect it to the
high-pressure washer.
► 1. Suction hose set
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Assembling the carrying handle
For the HW1200 only
1. Join the front and rear halves of the handle by
aligning the screw holes on the high pressure washer
body.
3
► 1. Front half of the handle 2. Rear half of the handle
3. High pressure washer body
2. Secure the carrying handle with screws(7 pcs).
1
6 ENGLISH
1
2