Waring Commercial MX Série Mode D'emploi page 3

1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it. Do not
fill above MAX line.
3. With the unit in STANDBY
container on blender base. Be sure container is
fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
4. This blender has 2 speed settings: HI
to desired position. To crush ice quickly, use HI
5. When finished blending, set paddle switch to STANDBY
6. This blender is equipped with a PULSE
down to engage PULSE
paddle switch is released.
7. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
8. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
9. Wash and dry container after each use. See Cleaning and Sanitizing
instructions.
1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it. Do not
fill above MAX line.
3. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
4. This blender is equipped with an electronic membrane keypad. The key-
pad has a main power STANDBY
PULSE buttons.
5. Press the STANDBY
illuminate. For continuous operation, press either LO or HI
When finished blending, press STOP
press the PULSE
button is released.
NOTE: Your MX Electronic Blender uses a Slow Start
pressing HI
then switch to HI
dients in container.
MX MECHANICAL SwITCHES
MX ELECTRONIC TOUCHPAD SwITCHES
wITHOUT SOUND ENCLOSURE
button to turn on the blender. Green LED will
button; motor will run on HI
, the unit will start in the LO speed for 2 seconds and
speed. This allows for a more even blending of ingre-
position, place
and LO . Press Paddle Switch
function. Unit will run on HI
button, plus HI , LO , STOP
. For momentary operation,
3
speed setting.
option. Hold paddle switch
speed until the
speed until the
feature. When
™
position.
and
button.