Waring Commercial MX Série Mode D'emploi page 11

To remove the sound enclosure, unplug your blender and follow these steps:
1. Open sound enclosure and remove blender container.
2. Remove front portion of sound enclosure by disengaging both sides at
the pivot point.
2. Remove rubber jar pad.
4. Remove 3 screws from blender base and remove sound enclosure.
Whether your blender is in STANDBY mode, NEW PROGRAM mode, or
the motor is running, pressing the ON/OFF
from running and will turn the power off. The LCD display will turn off.
NOTE: All programs and current settings will be restored next time you
turn unit on.
THE CONTAINER MUST BE CLEANED AND DRIED AFTER EACH USE
OF THE BLENDER ACCORDING TO THE FOLLOWING INSTRUCTIONS.
FAILURE TO DO SO MAY ALLOW RESIDUES OF PROCESSED MATERIAL
TO COLLECT ON THE INTERNAL SEALS OF THE BLADE ASSEMBLY,
RENDERING THEM INEFFECTIVE.
• Wash, rinse, sanitize and dry container prior to initial use and whenever
it will not be used again within a period of 1 hour.
• Wash and rinse container after each use.
• Clean and sanitize motor base prior to initial use and after each use.
• Washing solutions based on non-sudsing detergents and chlorine-based
sanitizing solutions having a minimum chlorine concentration of 100 PPM
are recommended.
The following washing, rinsing, and sanitizing solutions, or their equivalents,
may be used.
SOLUTION
Washing
Diversol BX/a or CX/A
Rinsing
Sanitizing
• In repetitive batch-processing applications, frequent cleaning of the
container will prolong the life of the blade assembly. In no case should
actual running time between cleanings exceed ½ hour.
• Do not use container to store processed foods or beverages.
REMOVING THE SOUND ENCLOSURE
TURNING OFF YOUR BLENDER
CLEANING AND SANITIZING INSTRUCTIONS
PRODUCT
Diversy Wyandotte
Plain Water
Clorox
®
Institutional Bleach
button will stop the unit
DILUTION IN wATER TEMPERATURE
4 Tablespoons/
3.8 Litres
1 Tablespoon/
3.8 Litres
11
Hot 46˚C
Warm 35˚C
Cold 10 – 21˚C