Technical Data - Bavaria BMG 135 Kit Mode D'emploi

Anleitung_BMG_135_Kit_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Items supplied (Fig. 1)
1 Drive unit
2 Case
3 Flexible shaft
4 Table clamp
5 Telescopic stand rod
6 Set of accessory parts
3. Layout (Fig. 2)
1 ON/OFF switch
2 Speed controller
3 Collet chuck nut
4 Locking knob for collet chuck
5 Cover
19.12.2008 9:24 Uhr Seite 9
4. Proper use
The Grinding and Engraving Set is designed to
perform drilling, grinding, deburring, polishing,
engraving, cutting, milling and cleaning jobs on
wood, metal and plastic in model-making, workshop
and household applications. Use the tool and
accessories only for those applications described.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Operating voltage of the drive unit: 230V ~ 50 Hz
Power input:
Idle speed n : max. 35,000 min
0
Clamping range:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 50144.
L sound pressure level 71.8 dB(A)
pA
K uncertainty
pA
L sound power level 82.8 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 50144.
Vibration emission value a ≤ 2,11 m/s 2
h
K uncertainty = 1.5 m/s 2
GB
135 W
-1
3.0 mm
II /
0.65 kg
3 dB
3 dB
9