Before Starting The Equipment - Bavaria BMG 135 Kit Mode D'emploi

Anleitung_BMG_135_Kit_SPK1:_
GB
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.

6. Before starting the equipment

6.1. Inserting the various tools (Fig. 2)
Before inserting a tool (and before each tool
change) switch of the drive unit and pull the power
plug.
1. Press the locking knob (4) and turn the collet
chuck until the bolt locks into place.
2. Undo the collet chuck nut (3).
3. Insert the required tool into the sleeve and tighten
the collet chuck nut (3).
6.1. Installing the flexible shaft (Figs. 2/4)
Unscrew the cover (5) from the front of the
equipment.
Undo the collet chuck nut (3).
Insert the internal schaft (a) of the flexible shaft
into the collet chuck (3).
Tighten the collet chuck nut (3).
Now tighten the ring (b) on the multi-tool.
6.3 Using the stand (Fig. 5)
Fit the stand to a workbench
The stand is adjustable in height and can be
adjusted as shown in Fig. 5.
The multi-tool can now be attached to the stand.
7. Using the tool for the first time
Make sure that the drive unit is switched off.
Check that the mains voltage specified on the
rating plate of the power supply unit is the same
as your mains supply. Only then should you
insert the plug of the power supply unit into a
socket-outlet.
7.1. ON/OFF switch (Fig. 2)
Switch on the drive unit with the power switch (1).
7.2. Speed selector (Fig. 2)
The required speed can be set with the speed control
(2).
The correct speed depends on the tool used and the
type of material being processed.
10
19.12.2008 9:24 Uhr Seite 10
7.3 Directions for use
With small milling cutters / grinding pins: Use a
high speed.
With large milling cutters / grinding pins: Use a
low speed.
Precision work / engraving: Hold the drive unit
like a pen.
Rough work: Hold the drive unit like a hammer.
7.4 Tips
Exert only moderate pressure on the workpiece
and allow it to be processed at uniform speed.
You will not finish your work sooner by exerting
heavy pressure. On the contrary, heavy pressure
will cause the drive unit to slow down or stop and
will overload the motor.
For your own safety, use a vise or screw clamp
to secure small workpieces.
8. Accessories (Fig. 3)
1 Grinding head
2 Grinding head caps
3 HSS drill bit
4 Whetstone
5 Clamping spindle for grinding and cut-off wheels
6 Cut-off wheel
7 Sanding disk
8 Grinding wheel
9 Holder for felt polishing pad
10 Polishing felt
11 Grinding pins
12 Engraving pins
13 Sleeve
14 Brushes
15 Collet chuck
16 Cutter
Description of the accessories:
Cutting disks:
For cutting metal and plastic.
Insert the cutting wheel onto the clamping spindle.
Grinding pins:
In various grinding head shapes.
For grinding and deburring metal and plastic.
HSS bits:
For drilling work on non-ferrous metals, wood, plastic
and printed circuit-boards.
Grinding wheels:
For cleaning and sharpening blades and tools. Insert
the grinding wheel onto the clamping spindle.