Connection - Velleman-Kit K8040 Mode D'emploi

CONNECTION

Place the amplifier in a well ventilated area. Never operate the amplifier inside a non
ventilated area. Connect the amplifier input to the output of an appropriate pre-amplifier
or control amplifier (e.g. our K4100, K8020, K8021). Use good quality audio leads.
Respect the Left and Right channels in a stereo configuration. Connect the power-cord to
the AC power connector. Check for correct mains voltage.
Turn off the Power before making any connection !
1. Mains power switch. Use this switch if the unit
is not used for a longer period.
2. AC Power indication.
3. AC Power and fuse holder, replace fuse only
with indicated ratings!
4. Speaker output connectors, use good
quality speaker wires of 4mm or higher.
Respect the speakers polarity.
5. Signal input connector. Use good quality cords
for connection with pre- or control amplifier.
6. Signal bypass output. Use this output if
separate amplifiers and speakers are used
for low and high frequencies.
See setup examples pages 24 and 25
The nominal input signal is 0.775V (0dB) for maximum output.
Connection
5