Pulse Counter; Led Display - Abus AZBW20000 Mode D'emploi

To change the settings: press the program button from Fig. 10 to get the options, i.e. 1x for the
range, 2x for the pulse counter, 3x for the LED. Wait 4 seconds until the blue LED display goes
out. The current setting appears in the display.
To change the setting for this option, press the button until you reach the required
setting. The display lights up twice and the changes are saved. Each change made to
the settings is transferred to the detector memory and remains there, even if the
voltage cuts off.
EXAMPLE: To change the LED setting from off to on.
Press the program button three times and then release.
Wait until the display goes out.
The display flashes once.
Press the program button twice and then release.
The display flashes twice to indicate that the option has been saved and the detector returns
to normal mode.
Setting options

PULSE COUNTER

The number of events which both sensors have to detect before an output
is indicated.

LED DISPLAY

LED off – LED switched off
LED on – LED indicates a detection