Publicité
Les langues disponibles
Les langues disponibles
Installation
Optional for wall break contact
Cable holes
Fig. 1
Template
The electronics must be protected against damp conditions during installation, as this can
seriously damage the device. Use the template supplied to drill the holes for the two fastening
screws on the cable input wall break contact (if used).
See Fig. 1 and 2. Note: For uneven surfaces we recommend using the adapter for the rear
tamper. Remove the front cover of the detector by first loosening the allen screw with the
supplied allen key (Fig. 3.1) and then using provided plastic release tool to release the side
catches (Fig. 3.2). Once the allen screw and both side catches are released, the cover can be
lifted up and out of its groove. (Fig. 3.3)
Publicité
