Astralpool LUMIPLUS PAR56 Manuel D'installation Et D'entretien page 3

5. MAINTENANCE:
This lamp does not require any type of maintenance work. If you notice that the lamp is not working properly, please
contact our customer attention service.
THIS PRODUCT DOES NOT CONTAIN ANY ELEMENTS THAT CAN BE HANDLED, DISMANTLED OR REPLACED
BY THE USER. IT IS FORBIDDEN TO ACCESS INSIDE THE PRODUCT, OTHERWISE THE GUARANTEE OF THE
6. ELECTRICAL CONNEXION
6.1. MONOCOLOR LAMPS (see diagram page 26)
The electrical connection of the monocolour lamps consists solely in turning the system on and off.
6.2. RGB LAMPS
The LED lamp can be controlled in two different ways: either by a normally closed pushbutton or by means of the
modulator and/or remote control.
In both cases, you should make sure that the voltage received by the lamp is never more than 12V AC.
The lamp should only be operated underwater and anchored to the vertical walls of the pool.
6.2.A. LumiPlus ECO: pushbutton control
The system has 14 operation modes: 7 set colours and 7 sequences of different colours. The colour or sequence is
changed by a quick press of the pushbutton. The lamp/s is/are placed in white if the pushbutton is pressed for longer.
Electrical connection diagram (see diagram page 26)
The LumiPlus ECO system is composed of the projector/s, the transformer and the normally closed (NC) pushbutton.
The Transformer must be dimensioned to supply the corresponding VA to each LED lamp which is connected (see table
on back page). For example, if we want to control 4, 64VA PAR56 V2 lamps we must connect them in parallel to a
minimum 300VA transformer.
The pushbutton must be able to withhold the power consumed by the number of lamps installed.
Operation modes
The LumiPlus ECO unit enables different light scenarios to be created inside the swimming pool with two operation
possibilities:
Set colour: Selection of one set colour out of seven possibilities.
Automatic colour sequence: Selection from among seven programmes of colour sequences. Each programme is defined
by the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE
1 Red
2 Red
3 Magenta
4 Red
5 Magenta
6 Yellow
7 Green
The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example,
if you are in colour 5, by pressing once, you will reach colour 6. If you press once again, you will go to sequence 7. If
you are in sequence 7, press once and you will get to colour 2, which is Red.
Colour 1, corresponds to white and is reached by one long press.
6.2.B. LumiPlus TOP: Modulator control and/or Remote control
The system has 20 operation modes: 12 set colours and 8 sequences of different colours.
The Modulator controls switching the lamps on and off, changes of colour and sequences and switching off timing.
PRODUCT WILL BECOME INVALID.
COLOUR Nº
1
2
3
4
5
6
7
ORDER OF COLOURS
Blue Green
Green Cyan
Cyan Yellow
Blue Green
Cyan Yellow
Magenta Cyan
Red Blue
3
COLOUR
White
Red
Blue
Green
Magenta
Cyan
Yellow
Magenta
Blue
-
-
-
-
-
Cyan Yellow
Magenta Yellow
- -
- -
- -
- -
- -