Arctic Air 17013-G Mode D'emploi page 10

customer service. You will find the
contact details on the last page of the
instruction manual.
• If the supplied cable does not work
correctly, please contact customer
service in order to avoid possible
dangers.
• When removing the cover for
changing of the filter, the ventilator
switches itself off and the water tank
begins to blink red until the cover is
put back on. This is a safety device.
TIPS:
• Place the Arctic Air™ on a raised
surface, something like a dining table,
desk or a sideboard.
• After refilling of the water tank and
before use, let the filter absorb water for
at least 3 minutes. This will provide you
quicker with cooler air.
• You will feel the best effect if
you sit directly in front of the
Arctic Air™
• With one filling the Arctic Air™ operates
at the lowest level for approximately 8
hours. Also when the water tank is
already empty, the filter remains damp
and the Arctic Air™ continues to cool.
• The colder the water used, the cooler
the effect. You may, therefore, also use
iced water or water with ice cubes.
SETTING UP:
1. Place the Arctic Air™ on a level base
(see illustration 1).
2. Open the water tank and fill it up
(see illustration 2). For this we
recommend a jug or beaker.
10
M16129_ArcticAir_Manual_20180628_BS.indd 10
3. Plug the broader end of the cable into
the power supply (TM-K007VC-
00501500PH-02) and connect the
power supply to a socket. Then plug
the narrower end of the cable into the
connection jack on the rear side of
the Arctic Air™ (see illustration 3).
NOTE: You can also connect the
broader USB-end to a computer. (DC
5V, 1,5A – 2,0A)
USE:
1. Press the on/off switch to power up the
Arctic Air™ (see illustration 4).
2. Set the speed of the ventilator by
pressing the control switch. You have a
choice of three modes - LO, MED and
HI (low, medium and high). The display
lights beside the switch will show you at
which speed the Arctic Air™ is currently
operating (see illustration 5).
3. Select the light colour by pressing the
control switch. You have the choice of
continual colours or colour-changing
mode (see illustration 6).
COLOUR SEQUENCE: Blue, red, white,
blue-green, purple, yellow, green.
Click all colours once to get to the
colour change mode. Click again to
turn off the colour completely.
4. To switch off press the on/off switch
again. NOTE: If you plan to not use the
Arctic Air for a long period of time, leave
the unit to run with an empty water tank
at the highest setting for at least 5
minutes, so that the filter can dry out.
LOW WATER LEVEL: If the water level is
low, the tank will blink three times, every
28.06.18 09:04