Cleaning And Maintenance; Accessories And Replacement Parts - Beurer HL 70 Mode D'emploi

Épilateur 3 en 1

Masquer les pouces Voir aussi pour HL 70:

Les langues disponibles

• Be aware that the underarm and bikini areas may be particularly sensitive to pain at first. We

therefore recommend that you use the lowest speed setting for the first use. The pain will less-

en with repeated use. As skin in this area is particularly sensitive after epilation, do not use any

substances that might irritate the skin such as alcohol-based deodorant.

Changing the attachment:

• To replace an attachment, press the unlock button and take the epilator

attachment off the device.

• Place the corresponding attachment back on the device, ensuring that

it clicks into place.

• Can only be attached in one direction.

• To change the shaver or exfoliation attachment, remove the attachment

from the attachment holder and then reinsert the attachment you wish

to use.

Note

We recommend that you use the shaver attachment on the second speed setting to achieve op-

timum results.

8. Cleaning and maintenance

WARNING

• Disconnect the device before cleaning it.

• Only clean the appliance in the manner specified. Fluid must never be allowed to enter

into the device or accessories.

• Clean the epilator attachment, the shaver and the exfoliation attachment with the clean-

ing brush. We recommend that you moisten this beforehand with alcohol to guarantee a

hygienic clean. Brush the attachments out from behind while you turn the roller by hand.

• Make sure that the relevant attachment is completely dry before you put in back on the

device.

• Do not use the device again until it is completely dry.

• Do not clean the device in the dishwasher.

• Do not use aggressive cleaning agents or hard brushes.

First unplug the device and allow it to cool off. Then you can clean it with a soft, slightly mois-

tened cloth. Then wipe it dry with a soft, lint-free cloth.

Accessories and replacement parts are available from the corresponding service address (ac-

cording to the service address list). Please state the corresponding order number.

Table des Matières