Filling & Installing The Water Reservoir - Vornado EVAP2 Guide De L'utilisateur

FiLLinG & inStaLLinG the
WateR ReSeRVoiR
This Humidifier has a 1.1 gallon capacity and 2 gallon output in 24
hours. When it needs refilling, follow these simple instructions: Unplug
the Humidifier. Be sure the Humidifier is placed on a firm, flat and level
surface (we recommend the floor). As with any water filled appliance,
spills can occur, so be careful when filling and installing the Water
Reservoir, and cleaning or moving the Humidifier.
addinG WateR
Remove the Water Reservoir by grasping the recessed handle and
pulling towards you. (A). Turn the Reservoir upside down. Remove
the Cap (B). If refilling the Reservoir, empty any water left inside the
Reservoir prior to refilling. Place the Reservoir in the sink upside down.
Fill the Reservoir with cool tap water (C). Once filled, insure the Gasket,
the rubber ring around the Cap, is in position and replace and fasten
the Cap. Some downward pressure may be needed to compress the
Gasket prior to rotating the Cap 1/4 turn clockwise to the fully installed
position.
inStaLLinG the WateR ReSeRVoiR
Lower the Reservoir into the Base, positioning the fill port over the
raised bump. The bump will activate the water outlet valve inside
the Cap once in a nested position. Insure the Reservoir is setting
firmly in the Base.
Quick daiLY maintenance
1. Empty Reservoir before refilling with clean water. Rinse, wipe clean and
dry with clean cloth or paper towel.
2. Refill Reservoir with cool, clean tap water. Do not overfill.
Lower humidity control settings or turn off Humidifier if moisture forms
3.
on walls or windows.
English | 7