Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INFLATION
Remove your Deluxe AeroBed
®
from its lightweight duffel bag. Keep bag for storage.
Note: Product must be at room temperature prior to inflating.
1. Place your rolled up bed on the floor or other surface free of obstructions or
sharp objects.
2. Make certain the Quick Air Release Valve located at the foot of the bed is closed.
Bed should be stored with valve in the closed and latched position.
If the Air Release Valve is open, close it by using 2 thumbs to push cover and
snap into valve. Be careful to avoid pushing valve cover to the right or left as it
snaps into the valve opening.
This is the closed position.
Open Air Release Valve
3. Remove AC plug, cord and One Touch
shrink wrap.
4. Plug into any standard polarized 110 Volt AC electrical outlet. North American
Electrical rating: 120 VAC 60HZ 1.0A (NOTE: 230VAC product sold outside of
North America.)
This product has a polarized attachment plug (one blade is wider than the other)
as a safety feature. This plug will fit into a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician. Never use with an extension cord unless the plug can be
fully inserted. Do not attempt to defeat this safety feature.
5. Push and hold the button of the One Touch Comfort
Control for approximately 60 seconds to inflate the
Deluxe AeroBed to full (firmest) capacity. Bed will not
over-inflate.
6. Attach the One Touch Comfort Control block to the
inflator by sliding it over the rubber nipple.
7. Lie on the bed to adjust the firmness to your desired level.
a.
To make the bed softer, depress the One Touch
Comfort Control block (not the button) and rubber
nipple together.
b.
To make the bed firmer, depress only the button of
the One Touch Comfort Control.
Close Valve Using 2 Thumbs
®
Comfort Control from plastic bag and
60 sec
aero
2
DEFLATION AND STORAGE
1. Make sure the bed is unplugged from the electric outlet
prior to deflation.
2. Open the Quick Air Release Valve at the foot of the bed to
release the air.
3. Roll or fold the AC cord with One Touch
block and secure it. Fold sides of bed into the center along
its length. Tightly roll your Deluxe AeroBed
pump towards the Air Release Valve end.
4. Roll the bed completely until all air is expelled. When
the Bed is completely rolled, push the Air Release Valve
closed until it locks.
5. Slide the duffel bag over your Deluxe AeroBed. Store your
Deluxe AeroBed in a clean dry place at room temperature
(above 50°F/10° C). Storing your Deluxe AeroBed under 50°
F (10° C) and over 100° F (38° C) may affect its
performance and will not be covered under warranty.
NOTE: Deluxe AeroBed must be at room temperature prior to inflating.

CARE AND MAINTENANCE

1. Inspect your Deluxe AeroBed prior to each use.
2. Keep your Deluxe AeroBed away from any sharp objects. Large cuts or snags
may not be repairable and will not be covered by your warranty.
3. When not in use, store your Deluxe AeroBed in its duffle bag, in a clean, dry
place out of extreme temperatures. Product must be at room temperature prior to
inflating.
4. Do not store your Deluxe AeroBed folded inside sofa beds or roll-aways. This
may cause damage to your Deluxe AeroBed that will not be covered under your
warranty.
5. In case of incidental damage to your bed, a repair kit has been included. Please
Inflation
follow repair instructions carefully.
Deluxe AeroBed
Your Deluxe AeroBed is constructed from quality cotton laminated to heavy-duty
vinyl. For spot cleaning, use a clear liquid dish detergent without dye, clean tap
water and a clean absorbent white cloth. Wet stained area thoroughly; gently
massage stained area with detergent. Blot the area to remove staining substance.
Rinse thoroughly and blot dry. Allow your bed to air dry completely after cleaning
and before storing.
Cover, if included
The mattress cover is made of 100% cotton. Machine wash in warm water with a
mild soap or detergent. Tumble dry on LOW HEAT.
®
Comfort Control
around the
®
CLEANING
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aerobed

Table des Matières