Battipav LEGGERA 6401E Mode D'emploi page 11

Battipav srl
TECHNICAL DATA
Tool:
Intended use:
CERAMICS, SINGLE-FIRED TILES,
USE
CAUTION
Each machine is carefully checked before leaving
the factory.
BATTIPAV is constantly developing its machines,
and so reserves the right to make any changes
without notice. As a result, the information and
illustrations in this manual may differ from the
machine supplied.
The LEGGERA tile cutter is a technologically
advanced, high performance machine that is suitable
for cutting ceramics, single-fired tiles and stoneware.
PRECAUTIONS
• The manufacturer accepts no responsibility
where the LEGGERA tile cutter is used with
any tools other than those specified in the
"RECOMMENDED USE" paragraph.
ASSEMBLY
Take the machine out of the packaging and check
that no parts have been damaged.
1
2 Position the cutter beam bracket and lock it into
place using the fastening knob.
TRANSPORT
3
The LEGGERA tile cutter can easily be
transported.
TUNGSTEN CARBIDE WHEEL
Art. 2009
PORCELAIN STONEWARE
PERFORMING THE CUT
CAUTION
4
• Position the tile to be cut on the resting surface
at the cut point required.
For greater accuracy, use the cutting indicator
and the relative tile support plate;
5
6
7 • Proceed by cutting into the glaze using the
cutting lever, exerting constant pressure
downward along the whole tile size;
8 • Move the foot to the break point then exert a
gradually increasing pressure until the tile is
separated.
DIAGONAL CUT
• Loosen the beam bracket's locking knob;
9
• Move the supporting beam bracket to an angle
of 45° as shown in photo 8.
• Position the tile to be cut on the work surface
and proceed with cutting as described in the
"PERFORMING THE CUT" paragraph.
ROUTINE MAINTENANCE
REPLACEMENT OF CUTTING SPARE WHEEL
10 • Using a 3 mm hexagonal wrench, remove the
screw from its seat and the locking nut cutting
wheel.
• Remove the worn cutting wheel.
Clean the surfaces from any residues.
For better smoothness of the cutting wheel,
it is recommended to lubricate the surface of
the locking screw with lithium grease.
Assemble again the screw and the locking
nut.
Always use original BATTIPAV spare parts
(Art. 2009).
GB
11