Handle Adjustment; Backrest Adjustment - Peg-Perego Sí Notice D'emploi

reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress are not approved
by the manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1• To open the chassis, pull the two levers on the
handlebars upwards (Fig.a); at the same time, lift the
chassis and it will open automatically (Fig.b). To make
sure that the stroller is correctly open, check the two
side hooks (Fig.c).
2• If the straps are not fasten correctly, press onto the
seat (fig_a) until it clicks into place.
Then push down into PUSH (fig. b) with your foot and
lift the front bar by one position (section 5b).
3• BASKET: To fit the basket, pull the loops over rear
hooks A and B and front hook C.
4• HANDLE ADJUSTMENT: The handles can be set at 3
different heights. To move them into the required
position, press the button and simultaneously pull the
handle upwards. To lower them, press the button and
push the handle down (fig_a).
BRAKE: To set the brake on the stroller, lower the lever
on the rear wheel unit with your foot. To release the
brake, lift the lever (fig_b). When stationary, always
apply the brake.
5• SWIVEL WHEELS: the wheels are already fixed into the
stroller.
In order to make the wheels swivel, the lever (arrow 1)
must be lowered. To secure the wheels, move the lever
to the opposite direction (arrow 2). The rear wheels
are fixed.
WARNING: Always keep the front bar fitted to the
stroller.
FRONT BAR: It is already attached to the stroller.
It can be put in 2 positions:
POSITION 1: Use.
POSITION 2: Folding.
To adjust it, press the two side buttons at the same
time (fig_b).
6• HOOD: To fit the hood, click the fasteners onto the
appropriate points and button down the hood on the
rear of the stroller's backrest (fig_a).
The hood can be set in 3 different positions (fig_b) by
simply pulling it forwards or backwards.
The section of netting can be pulled out from the hood
to protect the child from the sun (fig_c) and easily
replaced back inside when it is no longer needed.
7• COVER: in order to use the cover correctly (fig. a),
fasten the buttons in the inner part of the stroller (fig.
1) and lay it beneath the seat covering the footrest,
then fasten the buttons (fig. 2).
RAIN CANOPY: To fit the rain canopy, slip it onto the
stroller (fig_b), button it down on the sides of the
hood (fig_1) and attach the elastic loops, taking in the
chassis in the lower part of the stroller (fig_2).
8• 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
9• To tighten the waist strap, pull on both sides in the
direction of the arrow (Fig.a). To loosen it do the
opposite. The waist strap can be tightened as far as the
safety lock (Fig_b).
10• It is possible to set the safety harness at 3 different
heights, depending on how tall the child is. As the
child gets bigger, the harness must be moved to a
higher position.
11• To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
12• LEG REST ADJUSTMENT: The leg rest can be set in 2
different positions. To lower the leg rest, pull the two
side levers downwards and at the same time lower the
leg rest. To raise the leg rest, push it upwards until it
clicks into position.
BACKREST ADJUSTMENT: The backrest can be set in 3
positions: To lower the backrest, lift the levers on both
sides at the same time and lower it, locking it in the
position required. To lift the backrest, push it upwards.
13• FOLDING UP: Before folding up the stroller, it is best to
lower the front bar to position 2.
The stroller can be folded up using one hand only: pull
first one lever upwards and then the other, until they
click.
14• Hold the central handlebar and pull it upwards until
the stroller folds up (fig_a). Check the correct closure
of the chassis from the safety hook. When folded, the
chassis will stand upright (fig_b).
15• TRANSPORT: The stroller can be moved with ease (with
the front wheels fixed) using the central handle (fig_a).
It can also be carried using the side handle (fig_b).
16• REMOVABLE COVERS: To remove the cover of the stroller:
Release the two buckles on the rear of the backrest
(fig_a).
Release the two buttons on the seat (fig_b).
Pull the buckle of the crotch strap out from
underneath (fig_c).
Release the buttons from the side of the sack (fig_d).
17• Pull the sack off the footrest (fig_e).
To remove the safety harness, release the screws on
both sides, using a screwdriver and pliers to hold the
nut still (fig_f).
- 13 -