Special Product Features; Dust Extraction; Cleaning & Maintenance; Tips And Tricks - Metabo FMS 200 Intec Mode D'emploi

17026742_0606 FMS 200 Intec.book Seite 9 Donnerstag, 1. Juni 2006 11:41 11
5 Overview
See page 3 (please unfold).
1 Sanding disc
2 Sanding plate
3 On/off switch
4 Dust collection box
5 Cleaning flap
6 Fluted filter

6 Special Product Features

• Intec integrated extraction system
The integrated dust extraction system with the
Intec filter system permits dust-free work
without an extraction hose.
• Quick sanding disc change
Sanding plate with velcro-type fastening for
quick changing of the sanding disc.
• Wide variety of applications
Triangular sanding plate for sanding corners,
edges and surfaces.
• Long service life
Dust-protected quality ball bearings for a long
service life in continuous use.
7 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match your
power supply.
7.1 Installation of sanding disc
Simple attachment and removal thanks to the
velcro-type fastening.
Simply press on the sanding disc such that the
holes in the sanding disc (1) and sanding plate (2)
are aligned.
8 Use
8.1 Switching On and Off
Switching on:
Move switch (3) to "I" position.
Switching off:
Move switch (3) to "O" position.
ENGLISH
8.2

Dust Extraction

To optimise the dust extraction performance, fit
the sanding disc such that the holes on the
sanding disc (1) and sanding plate (2) are aligned.
Integrated extraction system:
Install the dust collection box (4) (see illustration,
page 3). To optimise the extraction performance,
empty the dust collection box (4) in good time and
clean the filter (6).
External extraction system:
Fit dust extraction nozzle (see chapter on Acces-
sories). Connect a suitable extraction device. Use
a suction hose with a 35 mm connector diameter.
See Accessories section.
9 Cleaning, Maintenance
Empty dust collection box (4).
- Open cleaning flap (5).
- Empty dust collection box (4).
- Remove fluted filter (6) and knock off dust stuck
to filter or remove with brush.
- When inserting, ensure that the fluted filter (6) is
inserted in the lateral guides.
Clean the machine regularly. This includes
vacuum cleaning the ventilation louvres on the
motor.
Replacing worn sanding plate (2)
- Remove fixing screws (on lower side of sanding
plate).
- Take off sanding plate.
- For sanding plate (as replacement), refer to the
Accessories chapter.
- Mount sanding plate.
- Refit fixing screws (on lower side of sanding
plate) and tighten.

10 Tips and Tricks

Do not press the device too firmly against the
surface being sanded. This does not improve, but
rather impairs, the sanding performance.
To optimise the extraction performance, empty the
dust collection box (4) in good time and clean the
fluted filter (6).
Use a suitable sanding disc to achieve the best
possible work results:
Removal of old paint layers = P 40
Pre-sanding of wood = P 60, P 80
Finishing of wood = P 100, P 120
Sanding of veneers, sealing primer, filler,
paint = P 180, P 240
ENG
9