Kerbl 29923 Mode D'emploi page 24

Press to select mode and press
setting by pressing
6.4 Selection of indicator address
This parameter is for selecting indicator address. There is a data for indicator address in the communica-
tion protocols. You can distinguish the different indicator by the address. The selection range is from
1-25. Please refer to 5.1 interface communication protocols in addenda to see the details of protocols.
Press to select address or
ting. He details are as follows:
6.5 Selection of BPS
This is used to select BPS. When BPS of the indicator and the communication equipment is not same, the
communication can't be used normally. Press
communication mode. Press
to enter the selection of indicator address. Enter the unit
. The details are as follow:
to enter the selection of BPS. Press
to enter the unit setting. The details are as follows:
to select BPS or
24
to enter the unit set-
to enter the selection of