Kerbl 29923 Mode D'emploi page 18

Bench scale 30 kg
EN
CONTENTS
1.0 CAUTIONS AND PREPARATION ..........................18
2.0 SPECIFICATIONS ................................................19
3.0 DISPLAY AND KEY DESCRIPTION ........................20
4.0 OPERATION INSTRUCTION .................................21
5.0 ALARMING FUNCTION .......................................22
6.0 SETTING INSTRUCTION ......................................24
7.0 ATTACHMENT ....................................................25
1.0 CAUTIONS AND PREPARATION
CAUTION
1.1 Please turn off the charge mode if you do not use the hydrogens battery of nickel or lead-aid
battery.
1.2 Avoid installing the balance in direct sunlight-this may cause poor performance or malfunctions.
1.3 Do not mix different type of batteries. Replace all the Batteries at the same time.
1.4 If the balance is not to be used for a long period of time, remove all batteries from the battery
compartment to avoid leakage which may cause damage to the instrument.
1.5 Avoid overloading or dropping material onto the platform because that could damage the balance.
1.6 Do not spill liquids on the balance as it is not water-resistant. Liquids may damage the case and
if it gets inside the balance it may cause damage to the electronics.
1.7 Material that has a static electric charge could influence the weighing. Discharge the static
electricity of the samples, if possible. Another solution to the problem is to wipe both sides of
the pan and the top of the case with an antistatic agent.
PREPARATION
1.1 Place your balance on a firm and level table, and then level the balance by adjusting the feet to
center the bubble in the spirit level.
1.2 Avoid placing the balance in direct strong sunlight or draught that may cause poor performance or
malfunctions.
1.3 Use the individual socket to avoid the interfere of other wirings.
1.4 Turn on the balance while there is no load on the pan.
1.5 Place the weight on the center of the pan for accurate weighing. Make sure the weight do not over
the Max capacity as it could damage the load cell inside.
1.6 We suggest to warm-up the balance for 5 minutes for accurate weighing.
1.7 Calibration may be required before weighing or when the balance is initially installed or moved
from a location
1.8 Please replace the battery when the low battery mark comes.
18