Cleaning; Trouble Shooting; Warranty Conditions - R&S Vibracap Mode D'emploi

mixing.
4.
When you have selected the tight time of mixing, push the bottom "S" to make operation. During the mixing, you can see
decreasing time. At the end of cycle, display will show the number of memory you used.
If the safety cover is opened during the mixing process, the circuit is broken and the motor stops automatically. The mixing
process might be finished by opening the safety cover or by pressing the button "S" again. When you turn off the main
switch, the amalgamator remains planed on the last operation it executed. Vibracap R&S fits capsules between 30 and 36
mm of length and with 14/18 mm of diameter.
Switch off the apparatus by disconnecting the mains cord. Clean housing, keypad and safety cover with a soft cloth and
customary aldehyde-free disinfecting solution. Do not clean with highly aggressive disinfecting solutions (e.g. solutions
based on orange oil or with an ethanol content of more than 50%), solvents (e.g. acetone), or pointed instruments, which may
damage or scratch the plastic. Make sure that no disinfectant, other liquid or foreign object enters the apparatus.
Note: All the information necessary for the repair of faulty components is made available by the manufacturer to the
technical personnel of the manufacturer approved dealer network who carry out the work.
1. Loud noise heard when mixing begins: remove transit screw.
2. Capsules are not secure: if the arms have become stretched, replace forks. (Contact an authorized service personnel for
replacement/installation)
3. Electrical or mechanical malfunction: Call your authorized service personnel.
The manufacturer, extends a 2 years warranty against defects in materials or workmanship to the original purchaser of
this product. The manufacturer agrees to correct any defects which develop within the warranty period, either by repair or
replacement, at its option. This warranty is valid providing factory inspection indicates that any such defect developed during
normal and proper use subject to the conditions below.
• Claims for damage in shipment should be filed promptly with the transportation company.
• All shipments claimed defective can only be returned to the manufacturer with the written consent of the manufacturer.
• All returned products must be accompanied by a full description of discrepancy or malfunction.
• Only the manufacturer authorized service personnel are allowed to carry out repairs to the unit.
• The manufacturer shall be released from all obligations under this warranty if repairs or modifications are made by
persons other than the manufacturer's own or authorized service personnel.
• Use only the manufacturer parts exclusively to replace defective components.
• The product warranty does not cover any damage resulting from the use of third-party replacements parts.
• The manufacturer shall be released from all obligations under this warranty in the event of improper installation;
damage due to casualty; or obvious misuse including but not limited to damage from liquids.
• The manufacturer shall in no event be liable for any consequential damages arising from the misuse of the product.
Only the above stated warranty shall be applicable, and all other warranties, expressed or implied, are hereby excluded.
All correspondence concerning the product should specify the model and serial number.

7. CLEANING

8. TROUBLE SHOOTING

9. WARRANTY CONDITIONS

i
13