Manual Working; Working With Memorized Times - R&S Vibracap Mode D'emploi

Vibracap R&S allows two different techniques of working: manual or with memorized times.

6.1 Manual Working

1.
Plan the wished time with the bottoms "+" and "-"
2.
Push the bottom "S" (Start). On display you will see the decreasing time. When the operation is finished, it will remain
planed.

6.2 Working with memorized times.

The machine is supplied with 10 planed times of mixing:
Mémoire 0 = sec. 4
Mémoire 1 = sec. 5
Mémoire 2 = sec. 5
Mémoire 3 = sec. 6
Mémoire 4 = sec. 7
Mémoire 5 = sec. 8
Mémoire 6 = sec. 9
Mémoire 7 = sec. 10
Mémoire 8 = sec. 11
Mémoire 9 = sec.
1.
Push the button "M". It will switch on the yellow light which indicates you are working with memories and it will show a
number with one figure which indicates the number of memory.
2.
Push the bottom "M" another time. Il will show a number with two figures (only for two seconds) which is relative to
mixing time corresponding to previous memory.
3.
Go on pushing the same bottom "M". It will show in succession the next number of memory with the relative time of
12
Mega + n°1 / Nogama 2 n°1 / Spherodon n°1
Mega + n°2 / Nogama 2 n°2 / Spherodon n°2
Tytin / Securalloy
Spherodon Slow Set / Dispersalloy
Mega + n°3 / Nogama 2 n°3 / Spherodon n°3
Duralloy / Permite C / ANA 70 / ANA 2000
Megalloy EZ / GS - 80
Advance
Amalcap
Advance 70
.............................................................
Fig. C
Fig. D