Options And Accessories - Hatco GR3SDH-27 Manuel D'installation Et D'utilisation

OPTIONS AND ACCESSORIES

Flip-Up Doors
Flip-up doors are available for all models as an added option at
the time of order. Flip-up doors can be installed on each shelf
on either the customer side or operator side of the unit. Use
the following procedure to install flip-up doors (the procedure is
the same for either side as well as each shelf).
1. Remove protective paper from acrylic surfaces.
2. Remove four screws (two on each side) from underside of
shelf.
3. Install each end bracket using the supplied end bracket
screws.
4. Place each end of the door into the installed end brackets
and secure using the hinge screws.
5. Remove screw towards outside of unit under the door
bracket location on either side of the unit.
6. Secure the door hook to the unit.
a. align the door hook screw through the shoulder washer
(facing up), door hook slot, and washer.
b. Screw the door hook screw into the proper hole
location.
NOTE: Door should swing fully up for product placement.
NOTE: When loading/unloading product, use door hook to hold
flip-up door in the open position.
End
Hinge
Bracket
Screw
Flip-Up Door Installation
Washer
Door
Hook
Shoulder
Washer
Door
Hook
Screw
End Bracket
Screw
Sneeze Guards
Sneeze guards are available for all models as an added option
at the time of order. Sneeze guards can be installed above each
shelf on the customer side of the unit.
1. Remove protective paper from acrylic surfaces.
2. Secure mounting bracket into position with studs facing to
the front and downward by loosening three screws from
underside of shelf, inserting bracket at slots, and tighten
screws.
3. Position the acrylic sneeze guard onto the warmer with the
mounting holes aligned.
4. Secure the sneeze guard using the acorn nuts provided.
Tighten until snug. Do not over-tighten.
Screw
Mounting
Bracket
Stud
Acorn
Nut
Sneeze Guard Installation
Shelf Sign Holder
a shelf sign holder (sign not included) is available for the top or
middle shelf on the customer side. The shelf sign holder is
available as a factory-installed option only.
4" (102 mm) Adjustable Legs
4" (102 mm) legs are available in lieu of the 2-1/2" (64 mm) legs
for installations that require additional clearance between the
unit and countertop.
Product Divider Rods
Stainless steel product divider rods are available as an
accessory.
3SD-DIV ................Stainless Steel Divider Rod
Designer Colors
Designer colors are available as an option at the time of order.
Plexiglass Side Panels
Plexiglass side panels are available as a factory installed option
in lieu of glass side panels.
14
English
Form No. GR3SDm-0915