Fault Finding Chart - BH FITNESS G6310 Instructions De Montage Et Utilisation

FAULT FINDING CHART

PROBLEM
1. The monitor
does not switch
on.
2. The monitor
switches on but
the motor fails
to start.
3. Walking motion
is jerky on the
treadmill.
4. The machine
stops (the
breaker trips).
5. Electrical shocks
through the
handrail.
6. The treadmill
belt skews off
centre.
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual)
CHECKS
1) Make sure that the
machine is plugged in,
the ON/OFF switch in
position 1 and that the
safety key is inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt
is lubricated.
3.b) Check the tension
on the sliding belt.
3.c) Check the tension
on the drive belt.
4) Check that the band is
lubricated.
5) Check that the
machine is plugged into
an earthed mains socket.
6.a) Check that the
machine is level on the
floor.
6.b) Check that the
machine does not
wobble.
19
SOLUTIONS
1) Plug the machine into
the mains supply. Set the
switch to position 1 and
insert the safety key.
2) Switch the machine off
and press the circuit
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust the belt
tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload
button with the On /Off
switch at „0" and
lubricate the treadmill
band.
5) Plug the machine into
an earthed mains socket.