Publicité
Les langues disponibles
Les langues disponibles
Egoa helps in preventing from moisture damage where books or valuables are stored, in
basements, etc.
Starting the Egoa
Before plugging the device on mains
power, check that the Egoa is turned off.
· Place the humidifier on the floor.
· Plug the power cord to the mains power and
turn the device on.
· The Egoa dehumidifier is now ready to use.
· When first using the dehumidifier, operate the
unit continuously for 24 hours.
· Check whether the filter is in place. Never use
the device without filter.
Operating instructions
⑭
· Press POWER
appliance. The LED
Egoa is on. The POWER pad blinks 5 times
per second when a humidity or temperature
sensor malfunction occurs.
· The humidity level can be set with humidity
⑫
control pads
humidity can be set within a range of 35% RH
(relative humidity) to 80% RH.
· When the Water full indicator light
Egoa shuts down.
⑪
to turn Egoa in continuous
· Press CONT
operation ; the indicator
CONT to cancel the continuous operation. This
function allows a maximum dehumidification.
The humidity level setting
when continuous operation is on.
Control panel description
· The digital panel shows the set humidity level
while setting.
· Then it shows the actual room humidity level.
· Error codes displayed:
- E1: humidity sensor error. Unplug the
unit and plug it back in. If the error persists,
contact after sales service.
- E2: temperature sensor error. Unplug the
unit and plug it back in. If the error persists,
contact after sales service.
- P1 : unit is defrosting. Allow time for the unit
to turn on and off the
⑧
remains green when
and digital display
⑨
⑩
glows. Press again on
⑫
cannot be used
⑬
to automatically defrost. The error will clear
after the unit self-defrosts.
- P2: the tank is full or not in the right position.
Empty the tank and/or replace it in the right
position.
Note: when more than one error occurs, the
error display order is: P2-E2-E1-P1
Other features
· The full tank indicator glows when the tank
is ready to be emptied, or when the tank
is removed or not replaced in the proper
position.
· Auto shut off: the water level shuts off the
dehumidifier when the tank is full, or when the tank
is removed or nor replaced in the proper position.
When the set humidity is reached, the unit will be
shut off automatically.
· Auto defrost: when the frost builds up on the
⑬
evaporator coils, the compressor will cycle
. The
off and the fan will continue to run until the
frost disappears.
·Auto
,
glows
unexpectedly due to a power cut, it will
restart with the previous setting automatically
when the power resumes.
· Wait 3 minutes before resuming operation.
After the unit has stopped, it cannot be
restarted for 3 minutes. This is to protect the
unit. Operation will automatically restart
after 3 minutes.
restart:
if
the
unit
breaks
off
9
Publicité
