Setting The Sleep Timer; Setting The Dimmer - Sonoro sonoroSTEREO Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 71
Restoring factory settings on the device
Fig. 18: Restoring factory settings
If necessary, all configured settings, such as language
and time formats and saved stations, can be reset to
factory settings (Fig. 18).
8.4

Setting the Sleep Timer

The Sleep Timer is an automatic power-off function
that switches the device to Standby mode after the
specified time has expired.
Switching the Sleep Timer on
Fig. 19: Switching the Sleep Timer on/off
1.
Press the [SLEEP] button on the remote control.
ð The display shows the [SLEEP] symbol
(Fig. 19/1).
Switching the Sleep Timer off
2.
To switch the Sleep Timer off, press the [SLEEP]
button again.
ð The symbol no longer appears on the display.
i
If the device was switched off by the Sleep Timer,
it will start in the most recently heard mode when
you turn it on the next time.
Setting the time interval for the Sleep Timer
Fig. 20: Setting the time interval for the Sleep Timer
1.
Press the [SLEEP] button on the remote control
for a long time.
i
Alternatively, you can also turn the click
wheel in the [Settings] menu until the display
indicates [Sleep Timer]. Press the click wheel
to confirm your choice.
© 2013
ð The display shows the Sleep Timer (Fig. 20)
and the [SLEEP] symbol flashes (Fig. 20/1).
2.
Turn the click wheel to select the desired length
of the interval (Fig. 20/2).
i
The maximum interval is 120 minutes.
3.
Press the click wheel to confirm the settings.
ð When the specified time expires, playback
gradually fades out.
8.5

Setting the dimmer

You can use the dimmer setting to adjust brightness
of the display background.
Fig. 21: Setting the dimmer
1.
Press the [DIMMER] button on the remote con-
trol for approx. 2 seconds.
i
Alternatively, you can also turn the click
wheel in the [Settings] menu until the display
indicates [Brightness level]. Press the click
wheel to confirm your choice.
ð The display indicates [Light High] (Fig. 21/A).
2.
Adjust the brightness from 8–15 by rotating the
click wheel.
3.
Press the click wheel or the [OK] button on the
remote control to confirm the setting.
ð The display indicates [Light Low] (Fig. 21/B).
4.
Adjust the brightness from 1–8 by rotating the
click wheel.
5.
Press the click wheel or the [OK] button on the
remote control to confirm the setting.
i
The backlight is set automatically depending on
the ambient lighting.
55

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

So-310

Table des Matières