Gedore DREMASTER Z Instructions D'emploi page 15

Safety Information:
Take the following safety information into account when using
the torque wrench in order to prevent accidents and damage.
 ALWAYS use original accessory parts approved by the
manufacturer.
 ALWAYS check the torque wrench for the proper torque
setting.
 ALWAYS position the torque wrench and socket
extensions at a 90° angle.
 When using socket extensions, e.g. for deep seated
screw positions, ALWAYS select the shortest possible
extension.
 If the resistance changes unexpectedly while tightening a
screw connection, IMMEDIATELY release the torque
wrench. Check the torque wrench and the screw
connection for damage.
 NEVER use reducers. The adaptor on the torque wrench
is designed for the forces intended. Reducers will not
bear the load.
 ALWAYS apply the torque wrench in the direction of
rotation specified. Follow the direction of rotation arrow.
 ALWAYS hold the torque wrench at the center of the
handle.
Tightening screws:
1) ALWAYS check the screw connection
for damage or wear.
2) ALWAYS determine
the screw connection's width
before tightening the screw.
3) ALWAYS select the
appropriate
accessory part.
4) Put this part on the torque
wrench's adaptor.
5) Take care that the catching elements latch when putting
the accessory part on the torque wrench's adaptor.
Check for a secure connection by lightly pulling on the
accessory part.
EN
17