ARDES AR4BL1 Mode D'emploi page 13

Press button (G) to increase the temperature or button (F) to decrease it: the set temperature
will change from a minimum of 15°C to a maximum of 40°C.
Once the desired temperature has been selected, the display (h) will show the room
temperature after a few seconds.
In automatic mode, the device will automatically regulate the heating power based on the
difference between the room temperature and the set temperature. In this operating mode,
the device will also switch between the various power levels (ventilation, low power, high
power) repeatedly. The selected power level is always shown on the display. Once the set
temperature has been reached, ventilation will still remain active in order to monitor the room
temperature more effectively.
To disable this function, press the "MODE" button (B) and manually select the desired
function (ventilation only, low power or high power).
MAINTENANCE
This appliance does not require any special maintenance.
Disconnect the plug from the socket and let the appliance cool down well before cleaning it.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from entering into the
apparatus and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
To clean the filter:
Press the clips (8), gently remove the back grill by pulling it outwards, remove the filter and
clean it using a soft slight damp cloth then replace in the appliance and reseal the back grill.
13 / 39