DS Produkte XJ-13406 Mode D'emploi page 17

■ Do not overfi ll the mixing bowl. This might result in the device overheating or dam-
age to the motor.
■ The device is equipped with overload protection that deactivates the device when
it overloads. If this occurs, immediately disconnect the plug from the socket and let
the device cool off for approximately 10 minutes. Afterwards, the device is ready for
use again.
■ Always assemble the device in full before you connect it to the mains power.
■ Do not leave the device unattended during operation!
■ During operation, keep children and animals away from the device in order to avoid
injury or damage to materials and the device itself!
■ Remove the mains plug from the plug socket before each exchange of the inserts.
■ Make sure that you do not use the inserts mixed up. Only either the dough hooks or
the stirrer inserts may be used at any one time.
1. Place the device on a dry, even and fi rm surface with suffi cient clearance around it.
2. Place the ingredients in the mixing bowl in accordance with your recipe.
3. Press the release button and attach the mixer head.
4. Insert the mixing bowl into the basic device. Rotate the mixing bowl clockwise to-
wards the closed lock symbol
you do so.
5. Choose the inserts you want (see the "Accessories" chapter).
6. Slide the inserts into the receiving socket on the mixer head. Note the markings (L
and R) on the inserts and the receiving socket. The insert with the marking R goes in
the receiving socket with the marking R. The same applies to the insert and receiv-
ing socket with the marking L.
7. Turn the insert to the right until the locking lug fi ts in the recess provided in the re-
ceiving socket. The insert must be heard to engage in place.
8. Press the release button and fl ip down the mixer head until it clicks into the motor
unit.
9. Make sure that the switch for adjusting the speed settings is in the 0 position before
you connect the device to the mains power in order not to switch the device on ac-
cidentally.
10. Set a suitable speed setting using the switch for adjusting the speed settings:
0 Off
1 - 3 Slow mixing, stirring and kneading
4 - 6 Fast mixing, stirring and kneading
11. To get even mixing, stirring and kneading, the bowl can be turned by hand and be
moved back and forth with the aid of the lever (on the front of the basic device).
12. To switch off the device, move the switch for adjusting the speed settings to position
0.
Danger of injury! Always wait until the inserts have come to a complete
standstill before you set the mixer head.
13. Press the release button and attach the mixer head.
14. Remove the inserts by pressing the eject button on the top of the mixer head.
17
(on the basic device). Hold the turntable fi rmly as
EN