Water Connection - Schulthess Perla SG 55I Notice D'utilisation

2. Push the appliance in and pull the mains
cable and the hoses through. Make sure
that they are not kinked or squashed.
3. Align the appliance and attach it on the
two sides in the upper area of the tub.
Other attaching possibilities
1. On the plinth.

Water connection

Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an
external thread of 3/4".
Caution! Do not use connection hoses
from an old appliance.
The water pressure must be in the limits (refer
to 'Technical data'). Make sure that the local
50
2. Additional bracket on the top. This is
available as a special accessory. Contact
the Service Force Centre.
water authority gives you the average mains
pressure in your area.
Make sure that there are no kinks in the water
inlet hose and that the water inlet hose is not
squashed or entangled.
Fit the locknut correctly to prevent water
leaks.
We recommend that you install an IRG filter.
Caution! Do not connect the appliance
to new pipes or pipes that are not used
for a long time. Let the water run for
some minutes, then connect the inlet
hose.
The water inlet hose is double-walled and
has an inner mains cable and a safety valve.
93