Channel Selection - AUDIOropa Xepton-NX Mode D'emploi

2.5 Audio outputs »EAR1« and »EAR2«
The earphones ER-01 (included) can be plugged
into any of the outputs »EAR1« or »EAR2«.
The 3,5 mm audio jack makes it possible to
connect various audio reproduction equipment,
such as earphones, headphones, neckloops but
also audio amplifiers and more.
A simultaneous use of both outputs is possible
but the volume cannot be adjusted separately.

2.6 Channel selection

Switch the device on and press the MODE-button
for 3 seconds.
The symbol »CH« in the display will blink. Select
a channel of 0-7 by pressing the » « and » «
 
buttons. After the selection, wait for 3 seconds to
set the selected channel number.
Please note:
Transmitters and receivers must be set to the
same group number if they are to communicate
with each other.
English 16